Is there any Div B team that is promoting the use of Fusion 360 among its builders?

For anything Science Olympiad-related that might not fall under a specific event or competition.
Post Reply
MarcHermann
Member
Member
Posts: 1
Joined: February 1st, 2024, 11:46 pm
State: CA
Pronouns: He/Him/His
Has thanked: 0
Been thanked: 0

Is there any Div B team that is promoting the use of Fusion 360 among its builders?

Post by MarcHermann »

Is there any Div B team that is promoting the use of Fusion 360 among its builders?
Top
User avatar
gz839918
Admin Emeritus
Admin Emeritus
Posts: 242
Joined: April 27th, 2019, 6:40 pm
Division: Grad
State: WI
Pronouns: She/Her/Hers
Has thanked: 454 times
Been thanked: 381 times
Contact:
Contact gz839918

Re: Is there any Div B team that is promoting the use of Fusion 360 among its builders?

Post by gz839918 »

I don't know about any Division B teams that are using Fusion 360, but it's a very challenging program to learn even for high schoolers and adults. Early exposure can still be beneficial for middle schoolers, but be sure not to set your expectations too high for build-related purposes.

TinkerCAD can be a helpful entry point into CAD before moving onto more advanced software like Fusion 360.
I ❤ sounds of music! About me • Rate my tests
The University of North Carolina at Chapel Hill ’23
Johns Hopkins University ’26

Those who are kind have the wealth of the mind :)
Top
thesaga
Member
Member
Posts: 24
Joined: February 1st, 2024, 6:06 pm
Division: B
State: NJ
Pronouns: He/Him/His
Has thanked: 11 times
Been thanked: 2 times

Re: Is there any Div B team that is promoting the use of Fusion 360 among its builders?

Post by thesaga »

Sorry for replying on an old post but is there is an easier-to-use version of onshape?
“If at first you don’t succeed, call it version 1.0.”
— Anonymous
Oh here's my user page btw: thesaga's Userpage
Top
Post Reply

Return to “General Competition”

Who is online

Users browsing this forum: No registered users and 0 guests