Building a testing base
-
waffletree
- Member
- Posts: 235
- Joined: Wed Mar 28, 2018 2:30 pm
- Division: C
- State: PA
- Has thanked: 0
- Been thanked: 0
Building a testing base
Hi, I am getting to the point where I am almost ready to start testing, and we don't have a testing base. I'm planning on building one with plywood, does anyone have any suggestions on the best way to make one? Thanks
builder cult vp // #treegang
-
TheSquaad
- Member
- Posts: 166
- Joined: Sat Mar 18, 2017 5:14 pm
- Division: Grad
- Has thanked: 0
- Been thanked: 5 times
Re: Building a testing base
An easy and portable way to make a wall is to stand up a plank and glue two other planks flat on the ground on either side of the stood-up plank.
-
knightmoves
- Member
- Posts: 482
- Joined: Thu Apr 26, 2018 6:40 pm
- Has thanked: 2 times
- Been thanked: 74 times
Re: Building a testing base
If it's not for competition, you don't need to make it the regulation 40cm wide. Build an L shape, with bracing to hold the right angle together. Clamp the base to a table.waffletree wrote:Hi, I am getting to the point where I am almost ready to start testing, and we don't have a testing base. I'm planning on building one with plywood, does anyone have any suggestions on the best way to make one? Thanks