Testing base

[M017]

Does anyone think the towers hopper could be modified to fit a boomilever test "wall", instead of buying a completely new setup

[waffletree]

Does anyone think the towers hopper could be modified to fit a boomilever test "wall", instead of buying a completely new setup

I think you could adjust the towers hopper, its essentially the same thing, with a few changes in positioning. If you are using the one from cbhoppers, you'd have to stabilize the wall on a table with the boomilever hanging off the edge of the table and have the towers hopper facing the table. And you would have to remove the towers testing table thing from the setup, but I think it would be possible.