Page 32 of 43
Re: Robo-Cross B
Posted: April 11th, 2009, 6:37 pm
by GGuy5
I don't know i don't have the robot anymore, but ask DaOoof, computernerd
Re: Robo-Cross B
Posted: April 12th, 2009, 10:20 am
by computernerd4826
hbk.showstopper wrote:wouldn't it just be better to like use the vex......like all the time
thats what i would say
Re: Robo-Cross B
Posted: April 12th, 2009, 11:26 am
by sachleen
GGuy5 wrote:The arm wasn't connected the VEX on ours it had a separate controller that was small(we named it the weenie remote
) so it didn't spaz, but to answer robotman's Q, it would resist our controller input sometimes and go backwards. It also had jolts of movement, it even burst forward a couple times
That's an issue I had with my VEX robot for Robot Ramble as well. It's cus of all the metal, If your antenna is high above everything else then it should be better. It was interesting to see what happens when you touch the antenna on the remote to the metal on the bot while both were ON.
Re: Robo-Cross B
Posted: April 12th, 2009, 5:01 pm
by haven chuck
For us it was the vex that spazzed out
Re: Robo-Cross B
Posted: April 12th, 2009, 9:45 pm
by Bridges and Bots
haven chuck wrote:For us it was the vex that spazzed out
That happened to our past vex as well. And it is because controllers from the vex kit can control any other vex receiver, so it most likely is just someone else with another vex nearby.
Re: Robo-Cross B
Posted: April 13th, 2009, 5:44 am
by computernerd4826
Re: Robo-Cross B
Posted: April 13th, 2009, 7:48 am
by GGuy5
nope, didn't think about that, but thanks
Re: Robo-Cross B
Posted: April 13th, 2009, 8:18 pm
by hbk.showstopper
hey thats a good idea
I knew that....
Re: Robo-Cross B
Posted: April 14th, 2009, 3:02 pm
by computernerd4826
yeah we have every crystal set, just in case
Re: Robo-Cross B
Posted: April 14th, 2009, 7:49 pm
by yousmellchinese123
What happens when you replace he crystals?
All it does is change the frequency at which it is used right?