Page 4 of 4
Re: Mousetrap Vehicle B
Posted: January 11th, 2020, 7:46 am
by neerja.shah
Unome wrote: ↑October 16th, 2019, 12:42 pm
bernard wrote: ↑October 16th, 2019, 10:14 am
A track
diagram for Mousetrap Vehicle has been posted to the national website.
This is truly the coolest of diagrams. I'm looking forward to running the event at Chattahoochee in a few months.
whats different of this diagram then other years?
Re: Mousetrap Vehicle B
Posted: January 11th, 2020, 7:58 am
by neerja.shah
what is everyone using for wheels? we were gonna use small wheels but our vehicle is only going 6 meters (on average) with the wheels. any suggestions to make it go further?
Re: Mousetrap Vehicle B
Posted: January 15th, 2020, 6:27 am
by builder83
neerja.shah wrote: ↑January 11th, 2020, 7:58 am
what is everyone using for wheels? we were gonna use small wheels but our vehicle is only going 6 meters (on average) with the wheels. any suggestions to make it go further?
Bigger wheels, adjust kill arm length, increase/decrease axle diameter. Make a lighter car. Lots of youtubes on this.
Lots of wheel options. Google hobby wheels. We printed ours.
Re: Mousetrap Vehicle B
Posted: February 26th, 2020, 4:43 pm
by HippoLowercase
Hey, I got 4 bearings for my mousetrap vehicle, but now that I'm using them, I'm wondering if they might be too heavy. What are your thoughts on bearings? Also if bearings are too heavy, what are other options for reducing the friction in the axles?
Re: Mousetrap Vehicle B
Posted: February 26th, 2020, 6:51 pm
by MadCow2357
HippoLowercase wrote: ↑February 26th, 2020, 4:43 pm
Hey, I got 4 bearings for my mousetrap vehicle, but now that I'm using them, I'm wondering if they might be too heavy. What are your thoughts on bearings? Also if bearings are too heavy, what are other options for reducing the friction in the axles?
Bearings are worth the weight unless you're using insanely large ones, in which case you probably consider smaller ones (ex. 3/16"). You can also add graphite
Re: Mousetrap Vehicle B
Posted: February 27th, 2020, 6:15 pm
by FiveW's
Just out of interest even though this subforum isn't active I was wondering how teams are getting high speeds and 12 meters?Because we can't seem to do it.
Re: Mousetrap Vehicle B
Posted: March 1st, 2020, 7:34 pm
by thedud
What would be a good material for my drive arm? Right now I have a fishing pole but it is bending so it is not working that well.
Re: Mousetrap Vehicle B
Posted: March 2nd, 2020, 6:19 pm
by HippoLowercase
Does the type of string have an impact on the distance or speed of the vehicle?