Mission Possible C

User avatar
Unome
Moderator
Moderator
Posts: 4315
Joined: Sun Jan 26, 2014 12:48 pm
Division: Grad
State: GA
Has thanked: 216 times
Been thanked: 75 times

Re: Mission Possible C

Post by Unome »

SluffAndRuff wrote:I don't recall if this has been discussed before, but what's your take on programming 9.9 second delays between every task?
Even though it complies with 3.i I'm sure there are some ESes that would penalize it as a violation of the spirit of the rules.
Userpage

Opinions expressed on this site are not official; the only place for official rules changes and FAQs is soinc.org.
dmis
Member
Member
Posts: 64
Joined: Wed Nov 01, 2017 5:44 pm
Has thanked: 0
Been thanked: 0

Re: Mission Possible C

Post by dmis »

SluffAndRuff wrote:I don't recall if this has been discussed before, but what's your take on programming 9.9 second delays between every task?
Personally, I'd say its against the spirit of the rules, but I doubt an ES would stop it. Its harmful anyway because it gives less time to get bonus points with a timer.
terence.tan
Member
Member
Posts: 178
Joined: Sun Sep 17, 2017 10:40 am
Division: C
State: NY
Has thanked: 0
Been thanked: 0

Re: Mission Possible C

Post by terence.tan »

SluffAndRuff wrote:I don't recall if this has been discussed before, but what's your take on programming 9.9 second delays between every task?
i think that you should go for it. I did that at my invitational and it was totally ok.
2017 events: Electric Vehicle, Game On, Robot Arm
2018 events: Mouse Trap Vehicle, Game On, Mission Possible, ExpD, Duct Tape Challenge
2019 events: Mouse Trap Vehicle, Sounds of Music, Mission Possible, ExpD, Wright Stuff, WIDI
2020 events: Gravity Vehicle. ExpD, WIDI, Sounds of Music, Machines
User avatar
bearasauras
Member
Member
Posts: 410
Joined: Tue Mar 04, 2003 8:33 pm
State: CA
Has thanked: 51 times
Been thanked: 115 times

Re: Mission Possible C

Post by bearasauras »

Remember that just because it was okay at one tournament, it doesn't mean it's okay at all tournaments.
jinhusong
Member
Member
Posts: 170
Joined: Thu Mar 16, 2017 3:34 pm
Division: C
State: CA
Has thanked: 0
Been thanked: 2 times

Re: Mission Possible C

Post by jinhusong »

$300 for all the electronics (no microcomputer). Many back parts.
davecutting
Member
Member
Posts: 34
Joined: Wed Oct 29, 2014 4:12 pm
Division: C
State: NY
Has thanked: 0
Been thanked: 0

Re: Mission Possible C

Post by davecutting »

Most of my actions are relatively instantaneous. Should I add a short delay of maybe 500 ms between each action? Most of my actions have an Attiny25 attached to them.
David Cutting
Ward Melville HS Science Olympiad
Hovercraft: Islip Invy 2[sup]nd[/sup], MIT Invy 26[sup]th[/sup], Regionals 3[sup]rd[/sup], SOUP 3[sup]rd[/sup], Statees 3[sup]rd[/sup]
Mission Possible: Islip Invy 11[sup]th[/sup], MIT Invy 11[sup]th[/sup], Regionals 1[sup]st[/sup], SOUP 2[sup]nd[/sup], States 2[sup]nd[/sup]
Game (Alternate): MIT Invy 32[sup]nd[/sup]
dmis
Member
Member
Posts: 64
Joined: Wed Nov 01, 2017 5:44 pm
Has thanked: 0
Been thanked: 0

Re: Mission Possible C

Post by dmis »

davecutting wrote:Most of my actions are relatively instantaneous. Should I add a short delay of maybe 500 ms between each action? Most of my actions have an Attiny25 attached to them.
Wow, thats a good way to save money but still use microcontrollers for everything. I would add a delay if you can easily because it will make it easier to prove actions happen in the sequence described in the asl.
Lambs
Member
Member
Posts: 10
Joined: Tue Jan 02, 2018 1:09 pm
Division: C
State: KS
Has thanked: 0
Been thanked: 0

Re: Mission Possible C

Post by Lambs »

To start the machine do you have to pull a magnet off or do you get to use andthing to start the machine?
User avatar
Unome
Moderator
Moderator
Posts: 4315
Joined: Sun Jan 26, 2014 12:48 pm
Division: Grad
State: GA
Has thanked: 216 times
Been thanked: 75 times

Re: Mission Possible C

Post by Unome »

Lambs wrote:To start the machine do you have to pull a magnet off or do you get to use andthing to start the machine?
You start by pulling the magnet off, as described in rule 4.a.
Userpage

Opinions expressed on this site are not official; the only place for official rules changes and FAQs is soinc.org.
absolutezerok3
Member
Member
Posts: 29
Joined: Thu Mar 09, 2017 9:37 pm
Division: C
State: MI
Has thanked: 0
Been thanked: 0

Re: Mission Possible C

Post by absolutezerok3 »

I'm using a 6v power supply but I can't run more than one circuit off of it. The circuits work fine individually but when operating together only the first one works. How can I get more juice out of this battery to power all the circuit I need without using additional batteries?

Thanks for everything
1|states MTV
[i]Disease Detectives[/i][b]| Mousetrap Vehicle |[/b][u] Circuit Lab [/u][b]| Mission Possible |[/b]Boomilever.
5 years and counting!!

Return to “Mission Possible C”