Page 13 of 22
Re: Shock Value B/Circuit Lab C
Posted: March 4th, 2013, 3:45 pm
by PicturePerfect
So, what exactly do you do in the hands-on part of this event?
Re: Shock Value B/Circuit Lab C
Posted: March 4th, 2013, 3:49 pm
by Skink
PicturePerfect wrote:So, what exactly do you do in the hands-on part of this event?
The rules offer some examples (like the bright light bulb task). Expect to have to build some sort of circuit and take measurements from it or a prepared one. Building materials could be as simple as snap circuits and go up in sophistication depending on what the supervisor has available.
Re: magnets, be ready for some simple magnet experiments, if anything at all.
Re: Shock Value B/Circuit Lab C
Posted: March 4th, 2013, 4:40 pm
by PicturePerfect
Skink wrote:PicturePerfect wrote:So, what exactly do you do in the hands-on part of this event?
The rules offer some examples (like the bright light bulb task). Expect to have to build some sort of circuit and take measurements from it or a prepared one. Building materials could be as simple as snap circuits and go up in sophistication depending on what the supervisor has available.
Re: magnets, be ready for some simple magnet experiments, if anything at all.
Cool, thanks!
Re: Shock Value B/Circuit Lab C
Posted: March 6th, 2013, 4:28 am
by UQOnyx
Does the current (amps) change or vary in a parallel circuit? I know it stays the same in a series circuit but my coach said that it can change in a parallel circuit.
Re: Shock Value B/Circuit Lab C
Posted: March 6th, 2013, 6:16 am
by Bozongle
UQOnyx wrote:Does the current (amps) change or vary in a parallel circuit? I know it stays the same in a series circuit but my coach said that it can change in a parallel circuit.
It doesn't "change". But the current through each resistor is different in a parallel configuration.
Re: Shock Value B/Circuit Lab C
Posted: March 7th, 2013, 11:17 am
by UQOnyx
Bozongle wrote:
It doesn't "change". But the current through each resistor is different in a parallel configuration.
Thanks. Trying to wrap my head around it, does voltage split evenly in a parallel circuit with two paths?
Re: Shock Value B/Circuit Lab C
Posted: March 7th, 2013, 11:27 am
by iwonder
The voltage would be the same across both branches, but the current would split relative to the resistance of each branch. If they had the same resistance, then the current would split evenly.
Re: Shock Value B/Circuit Lab C
Posted: March 7th, 2013, 11:35 am
by Skink
If you're struggling with it conceptually, think in terms of the water pipe analogy. I find that helps me make sense of what physically is going on with what iwonder said above.
Re: Shock Value B/Circuit Lab C
Posted: March 7th, 2013, 12:59 pm
by iwonder
That works too, all the comparisons are on the wiki if you need.
Re: Shock Value B/Circuit Lab C
Posted: March 7th, 2013, 3:00 pm
by UQOnyx
No, I get it thanks. I just find it easier asking on the forum than my teachers or looking it up
