Scioly.org

Either that or make your own, see link in my post above.

Jeff Anderson
Livonia, MI

lllazar wrote:Would you suggest buying a precision applicator (those long thin tubes)?

I cannot see how you could apply a sufficiently small amount of glue straight out of the bottle or tube.

old wrote:

lllazar wrote:Would you suggest buying a precision applicator (those long thin tubes)?

I cannot see how you could apply a sufficiently small amount of glue straight out of the bottle or tube.

Haha, well no wonder i was using so much glue last year....i think i can significantly get my mass down with that then

Btw, where do u think id find a legit one of these? Any local department stores (Lowes, HD)?

Decent chemistry pipet always seemed to work for me. Not one of those cheap plastic things you'll find in your average HS chemistry classroom. One of the glass ones with the rubber bulb that has a very small tip. Rinse it with acetone after use.

i just make one out of a scrap of balsa wood and a paper clip.

I used a high power hot glue gun and gorilla glue

also 5 minute apoxy

disownedpear wrote:I used a high power hot glue gun and gorilla glue

Very funny! I know you were joking around but remember that some of the people reading this forum really don't know what is a joke and what is serious.

Yes, let's try to keep information helpful please.

old wrote:

disownedpear wrote:I used a high power hot glue gun and gorilla glue

Very funny! I know you were joking around but remember that some of the people reading this forum really don't know what is a joke and what is serious.

I seriosly dought that he was jokeing.. I know him. Also, pear, dont double-post. You do it all the time. Use edit (top-right corner of post)