Top Finish Kits tower jig

jogden
Member
Member
Posts: 1
Joined: Sat Dec 14, 2024 7:12 pm
Division: C
State: MI
Has thanked: 0
Been thanked: 0

Top Finish Kits tower jig

Post by jogden »

I was pleased to find the Tower Jigs - 3D Models on the Top Finish Kits website. Very well done. However, with an important detail not considered. The Div C tower jig is based on the Science O template guide that was published last June. The offical rules include a scoring bonus if the base of the tower stands outside a 29 cm circle, but the TFK tower jig is smaller than that. The base width of one side is only 23 cm, and it must be greater than 25.2 cm if you want to go for the bonus points.
Top Finish Kits, would you consider publishing a new set of printer files, consistent with this larger base?

Return to “Tower B/C”