How much money you got? Castle brushless is the best.depo1213 wrote:So... where is the best place to buy a brushless motor
and which brand is the best
Electric Vehicle C
- windu34
- Staff Emeritus
- Posts: 1382
- Joined: April 19th, 2015, 6:37 pm
- Division: Grad
- State: FL
- Has thanked: 2 times
- Been thanked: 37 times
Re: Electric Vehicle C
Boca Raton Community High School Alumni
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
-
- Member
- Posts: 4
- Joined: November 4th, 2015, 4:29 pm
- Has thanked: 0
- Been thanked: 0
Re: Electric Vehicle C
Does anyone know a site where I can buy a kit or most of the materials?
Also which wheels are the best to use? Discs or something else?
Also which wheels are the best to use? Discs or something else?
- InfiniCuber
- Member
- Posts: 171
- Joined: October 20th, 2012, 6:15 am
- Division: C
- State: IN
- Has thanked: 0
- Been thanked: 0
Re: Electric Vehicle C
Here is the link to the EV kit on Ward Science, all the scioly kits are on there.clearmayhem wrote:Does anyone know a site where I can buy a kit or most of the materials?
Also which wheels are the best to use? Discs or something else?
A word of caution though: I personally don't think these kits are the best by any means or the end all be all to EV. It can be a good place to start, though!
As far as wheels, wheels are found in the kit. If you want wheels outside of that, I wouldn't recommend discs, like CDs. There was another post earlier in the forum here.
Scioly isn't a club, or an organization. It is a lifestyle.
~Munster High School Science Olympiad Captain 2016~
~Munster High School Science Olympiad Captain 2016~
- windu34
- Staff Emeritus
- Posts: 1382
- Joined: April 19th, 2015, 6:37 pm
- Division: Grad
- State: FL
- Has thanked: 2 times
- Been thanked: 37 times
Re: Electric Vehicle C
Depending on how much time, brains, and money you got. If you are using high speed motors, you will NOT want to use CD's because they will not "grab" the floor (coefficient of friction will be too small). Look into Banebots.clearmayhem wrote:Does anyone know a site where I can buy a kit or most of the materials?
Also which wheels are the best to use? Discs or something else?
Boca Raton Community High School Alumni
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
Re: Electric Vehicle C
I have a question I was hoping someone could answer for me without me having to submit a rules clarification. The rules state that "The vehicle may use no more than 6 individual cell (labeled 1.5 volts or less each), a single 9-volt battery, or a single battery pack (labeled 7.2 volts or less) at any given time during the 8 minutes. Batteries need not be installed until immediately prior to the run. Only electrical energy stored in these batteries may be used to propel the vehicle."
Then it goes on to say, " Additional energy sources may be used to operate other functions (e.g., braking system) provided these functions do NOT help propel the vehicle in any way."
So my question is this: would a battery that is used to power a microcontroller (that would not help propel the vehicle) need to be included into 6 cells or single 9 volt battery? When they say ADDITIONAL energy sources can be used to operate other functions, are they saying that you are permitted to add batteries outside the 6 cells or single 9 volt battery?
I understand that any rules clarifications are unofficial, but does anyone have an answer for me?
Thank you.
Then it goes on to say, " Additional energy sources may be used to operate other functions (e.g., braking system) provided these functions do NOT help propel the vehicle in any way."
So my question is this: would a battery that is used to power a microcontroller (that would not help propel the vehicle) need to be included into 6 cells or single 9 volt battery? When they say ADDITIONAL energy sources can be used to operate other functions, are they saying that you are permitted to add batteries outside the 6 cells or single 9 volt battery?
I understand that any rules clarifications are unofficial, but does anyone have an answer for me?
Thank you.
- samlan16
- Member
- Posts: 528
- Joined: December 30th, 2013, 2:54 pm
- Division: Grad
- State: GA
- Has thanked: 0
- Been thanked: 5 times
- Contact:
Re: Electric Vehicle C
Have any of you all started testing? If so, what is your average time over the 8 m stretch?
Old fart who sort of did things sort of for some schools.
- finagle29
- Exalted Member
- Posts: 51
- Joined: January 28th, 2013, 11:37 am
- Division: Grad
- State: PA
- Has thanked: 0
- Been thanked: 0
Re: Electric Vehicle C
At Cy Falls I saw teams get close to 3s.
Bayard Rustin HS Alum
2013 Events: Thermo, Circuit Lab, Experiment, Robot Arm
2014 Events: Circuit Lab, Experiment, TPS, Mat Sci, Astro
2015 Events: Astro, Chem Lab, Compound Machines, Experiment, Time, TPS
2016 Events: Astro, Cell Bio, Chem Lab, Electric Vehicle, Time, Protein Modeling, Wind Power
2013 Events: Thermo, Circuit Lab, Experiment, Robot Arm
2014 Events: Circuit Lab, Experiment, TPS, Mat Sci, Astro
2015 Events: Astro, Chem Lab, Compound Machines, Experiment, Time, TPS
2016 Events: Astro, Cell Bio, Chem Lab, Electric Vehicle, Time, Protein Modeling, Wind Power
- windu34
- Staff Emeritus
- Posts: 1382
- Joined: April 19th, 2015, 6:37 pm
- Division: Grad
- State: FL
- Has thanked: 2 times
- Been thanked: 37 times
Re: Electric Vehicle C
What motors or setups worked best?finagle29 wrote:At Cy Falls I saw teams get close to 3s.
Boca Raton Community High School Alumni
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
- finagle29
- Exalted Member
- Posts: 51
- Joined: January 28th, 2013, 11:37 am
- Division: Grad
- State: PA
- Has thanked: 0
- Been thanked: 0
Re: Electric Vehicle C
One of the teams that got close to 3s had one motor in the back driving a single wheel and two wheels in the front.windu34 wrote:What motors or setups worked best?finagle29 wrote:At Cy Falls I saw teams get close to 3s.
Bayard Rustin HS Alum
2013 Events: Thermo, Circuit Lab, Experiment, Robot Arm
2014 Events: Circuit Lab, Experiment, TPS, Mat Sci, Astro
2015 Events: Astro, Chem Lab, Compound Machines, Experiment, Time, TPS
2016 Events: Astro, Cell Bio, Chem Lab, Electric Vehicle, Time, Protein Modeling, Wind Power
2013 Events: Thermo, Circuit Lab, Experiment, Robot Arm
2014 Events: Circuit Lab, Experiment, TPS, Mat Sci, Astro
2015 Events: Astro, Chem Lab, Compound Machines, Experiment, Time, TPS
2016 Events: Astro, Cell Bio, Chem Lab, Electric Vehicle, Time, Protein Modeling, Wind Power
- windu34
- Staff Emeritus
- Posts: 1382
- Joined: April 19th, 2015, 6:37 pm
- Division: Grad
- State: FL
- Has thanked: 2 times
- Been thanked: 37 times
Re: Electric Vehicle C
Did you see what type of motor it was? brushless? Microcontroller?finagle29 wrote:One of the teams that got close to 3s had one motor in the back driving a single wheel and two wheels in the front.windu34 wrote:What motors or setups worked best?finagle29 wrote:At Cy Falls I saw teams get close to 3s.
so it was single-wheeled drive or three-wheeled drive?
Boca Raton Community High School Alumni
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
University of Florida Science Olympiad Co-Founder
Florida Science Olympiad Board of Directors
kevin@floridascienceolympiad.org || windu34's Userpage
Who is online
Users browsing this forum: No registered users and 3 guests