In this case I think volume should be a controlled variable, because it would affect reaction rate. however you could have still conducted your experiment, listed it as a control, and write about it in the error section.fourLoko wrote:Could you guys give me some input on this?
So I was thinking about a practice my team did about reaction rate with alka seltzer tablets. Our instinct was to test surface area vs reaction rate, so we divided up the tablets, calculated surface area, dissolved them, etc etc. The thing is though, for a larger tablet, wouldn't the reaction rate be influenced by both the increased surface area and an increased volume? I was thinking about trying to determine the relationship between the Surface Area/Volume ratio to time instead so it would account for both the surface area and volume. Am I overthinking this? Would a simple SA v time experiment have been sufficient?
Experimental Design B/C
-
- Wiki/Gallery Moderator Emeritus
- Posts: 433
- Joined: February 15th, 2011, 5:45 pm
- Division: Grad
- State: CA
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
- Cjkowalcz
- Member
- Posts: 125
- Joined: November 5th, 2012, 11:02 am
- Division: B
- State: PA
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
Are the topics at states anything different from what I should expect?
2014 Rustin Invitational:
Entomology: 5th
Experimental Design: 1st
2014 Regionals:
Entomology: 3rd
Meteorology: 2nd
Experimental Design: 1st
2014 States:
???
Medal Count: 14 (Hoping for 15 after my last B-division States
)
Entomology: 5th
Experimental Design: 1st
2014 Regionals:
Entomology: 3rd
Meteorology: 2nd
Experimental Design: 1st
2014 States:
???
Medal Count: 14 (Hoping for 15 after my last B-division States

-
- Wiki/Gallery Moderator Emeritus
- Posts: 433
- Joined: February 15th, 2011, 5:45 pm
- Division: Grad
- State: CA
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
What I do is basically state anything that has and could have gone wrong. Talk about errors with you data collection, such as faulty equipment. Then say the effect the errors had on your data, which would probably involve it being skewed one way or the other.Bozongle wrote:Can someone give me some advice for Errors? It seems to be the only one I'm consistently doing bad on in our practices.
- fozendog
- Member
- Posts: 193
- Joined: April 17th, 2012, 5:51 pm
- Division: Grad
- State: WA
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
A lot of the time you should be able to get your errors from your qualitative observations.
Stanford '19
Camas Science Olympiad Alumnus
Events: Protein Modeling, Cell Biology, Disease Detectives, Experimental Design, Dynamic Planet, Water Quality
Camas Science Olympiad Alumnus
Events: Protein Modeling, Cell Biology, Disease Detectives, Experimental Design, Dynamic Planet, Water Quality
-
- Member
- Posts: 2
- Joined: March 17th, 2013, 8:43 am
- Division: C
- State: MI
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
What does the rubric mean by "other ways to look at the given hypothesis"? I know it is not made extremely clear, but I would like to know what everybody else talks about in this section.
- JustDroobles
- Member
- Posts: 164
- Joined: February 9th, 2009, 3:28 pm
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
My interpretation was that you should describe another experiment that could test the same hypothesis as your experiment.aaronstar1 wrote:What does the rubric mean by "other ways to look at the given hypothesis"? I know it is not made extremely clear, but I would like to know what everybody else talks about in this section.
I know this is a silly example, and the actual experiment is more likely to apply to B division, but I think this should convey the general idea. Let's say your experiment was shooting gummy bears with a rubber band. Your hypothesis is "If the rubber band is stretched farther back, then the gummy bear will shoot farther." So in your experiment you just hold the rubber the band on the table, stretch it back with the bear inside, and let it launch the bear to slide across the table. Then in the "Applications and Recommendations for Further Use" you can say something like "A further experiment to test this hypothesis could be launching gummy bears with a catapult powered by rubber band, or launching gummy bears off the edge of the table. Then the effect of the bear's launch through the air could be studied instead of it sliding along the table."
-
- Member
- Posts: 122
- Joined: March 4th, 2013, 4:13 pm
- Division: B
- State: TN
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
I'm having some trouble with the analysis, I always mess it up or confuse it with conclusion. Does anyone have a good sample analysis that I can see?
I bet you had to read this twice
Meliores Sumus Te
Visit my Wiki page: http://scioly.org/wiki/index.php/Mrburrito
Meliores Sumus Te
Visit my Wiki page: http://scioly.org/wiki/index.php/Mrburrito
- JustDroobles
- Member
- Posts: 164
- Joined: February 9th, 2009, 3:28 pm
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
The analysis portion should discuss the data specifically, without regard to the hypothesis. Some things you should touch on are the trend the data showed, how accurate your regression and data points were, and whether you had any clear outliers.mrburrito wrote:I'm having some trouble with the analysis, I always mess it up or confuse it with conclusion. Does anyone have a good sample analysis that I can see?
The conclusion should specifically address the hypothesis and whether or not it was supported by your data. You should reference your data to support whatever claim you make, but not near the level of complexity that you would discuss it in the analysis section.
This document contains some sample write-ups to give you a feel for what should be included in each section: http://www.sciencenc.com/coaches-instit ... sent08.pdf
-
- Member
- Posts: 122
- Joined: March 4th, 2013, 4:13 pm
- Division: B
- State: TN
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
JustDroobles wrote:The analysis portion should discuss the data specifically, without regard to the hypothesis. Some things you should touch on are the trend the data showed, how accurate your regression and data points were, and whether you had any clear outliers.mrburrito wrote:I'm having some trouble with the analysis, I always mess it up or confuse it with conclusion. Does anyone have a good sample analysis that I can see?
The conclusion should specifically address the hypothesis and whether or not it was supported by your data. You should reference your data to support whatever claim you make, but not near the level of complexity that you would discuss it in the analysis section.
This document contains some sample write-ups to give you a feel for what should be included in each section: http://www.sciencenc.com/coaches-instit ... sent08.pdf
Thanks.
I bet you had to read this twice
Meliores Sumus Te
Visit my Wiki page: http://scioly.org/wiki/index.php/Mrburrito
Meliores Sumus Te
Visit my Wiki page: http://scioly.org/wiki/index.php/Mrburrito
- caseyotis
- Member
- Posts: 680
- Joined: October 25th, 2012, 7:53 pm
- Division: C
- State: NY
- Has thanked: 0
- Been thanked: 0
Re: Experimental Design B/C
I have this event in a couple of hours! I think I'm pretty prepared, but wish me luck! 

http://scioly.org/wiki/index.php/User:Caseyotis
Welcome, welcome
Welcome, welcome
“Goodbye,” said the fox.
“And now here is my secret, a very simple secret:
It is only with the heart that one can see rightly;
what is essential is invisible to the
eye.”
Le Petit Prince, Antoine de Saint-Exupéry
“And now here is my secret, a very simple secret:
It is only with the heart that one can see rightly;
what is essential is invisible to the
eye.”
Le Petit Prince, Antoine de Saint-Exupéry
Who is online
Users browsing this forum: No registered users and 0 guests